1. Peel back the label to reveal the vent holes.
2. Insert the syringe through the vent hole, and push into the center of the cartridge. The cartridge contains sponge and a slight resistance will be felt.
3. Slowly inject up to 5ml. of ink or until ink appears at the filling hole.
OR
1 Flip over the cartridge. Locate the sponge(s) on the bottom.
2 Inject the cartridge with about 2 cc of ink Be careful -- this sponge doesn't hold much ink!
Inject S-L-O-W-L-Y to fill the entire cartridge. Be sure to remove and re-insert the needle a few times to expose the entire sponge to the ink.
Note - Set on a paper towel for an hour as a drip precaution. Expect a few drips. Cover all holes during storage to prevent leaks and evaporation.
Unused ink may be returned to the bottle.
Replace the cartridge and run a priming cycle as per printer instructions.
