 |
 |
1. Put the cartridge on some paper towels in an area where you can tolerate a spill.
2. Drill a hole into the dimple just below the
"B". 
3. Fill the syringe with 15 ml. of black ink.
4. Very S-L-O-W-L-Y inject ink into any hole.
5. When finished, put a small piece of tape over the drilled hole.
6. Replace the cartridge and run 1 - 3 cleaning cycles as
per printer instructions.
If necessary leave cartridge in printer for up to 24 hours.
Note: Each time the cartridge is removed from the printer an "empty cartridge" message appears and a blinking amber light will come on, on the printer. Holding the paper feed button down for 3-5 sec. will allow you to override the counter.
